As soon as the Raspberry Pi M.2 HAT+ was released, lots of customers got in touch asking about Raspberry Pi 5 cases for it, so we got to work on our in-house laser machine and came up with this minimal solution! This \’layer case\’ is a simple combination of two Perspex layers and a set of carefully selected fixings to give your M.2 HAT+ setup a smart home to live in. We\’ve used our signature glass-look Perspex which everyone here agrees is super-posh and looks awesome. Updated! Following customer feedback, we now include a cut-out on the top panel for camera/display cables. Assembly is easy and you don\’t need any of the original HAT fixings if you\’ve misplaced them. All you need is a cross-head (Phillips) screwdriver and our assembly guide. Also compatible with the Raspberry Pi AI Kitand the Pineboards HatDrive! Top (without the header fitted) andTop Lite. Raspberry Pi, Active Cooler, M.2 HAT and NVMe device not included. Features A lovely little home for your Raspberry Pi 5 and M.2 HAT+ (or AI Kit) Layer case style – a stylish sandwich of Perspex for your hardware! All required fixings included – original HAT fixings are not required Option to use the original 16mm HAT+ spacers to increase spacing if you desire (our kits uses 15mm spacers) Cut-out to pass camera/display cables through to the CSI/DSI ports Vents in lower Perspex panel (not really required due to the open design,but hey we did it anyway!) Simple assembly – all you need is a cross-head screwdriver Rubber feet included Resources Assembly Guide Revision History As of 30/01/2025 – following customer feedback, we now include a handy slot on the top panel for camera/display cables. Package Contents 2x Glass-look Perspex layers 1x Fixing set 4x Rubber feet Raspberry Pi, Active Cooler, M.2 HAT and NVMe device not included.