JST-PH jumper wires are our favorite type of \”crimp\” connector. They\’re solid, reliable, compact, low-cost, easy to connect/disconnect, and simple to solder on most projects! JST-PH connectors are 8.0mm (.295\”) in height after mounting, 4.5mm (.177\”) in width and feature a low-profile 2.0mm (.079\”) pitch connector. All assemblies are 150mm (6\”) long and feature colour coding for easy hacking! We stock 2-wire, 3-wire, 4-wire and 5-wire JST -PH jumper assemblies, with a male JST connector on one end and bare cable on the opposite end. All assemblies come with a corresponding right angle female mating connector. These can be used in breadboards, but they\’re best used in soldered assemblies. Features 3 Pin JST PH Assembly & 3 Pin Right Angle Connector Current rating: 2A AC, DC (AWG #24) Voltage rating: 100V AC, DC Temperature range: -25?C to +85?C (including temperature rise in applying electrical current) Contact resistance: Initial value/10m ? max. After environmental testing/20m ? max. Insulation resistance: 1,000M ? min. Withstanding voltage: 800V AC/minute Applicable wire: AWG #32 to #24 Applicable PC board thickness: 0.8 to 1.6mm(.031\” to .063\”) The dimple at the center of the contact ensures positive contact and low contact resistance at all times. The contact has a long wire strip holding length of 2.6 +/-0.4mm. Fully shrouded header Downloads Manufacturer Website Datasheet